Devil Design launches an innovative product - a 110ml liquid adhesive for printing pads. This product provides improved surface adhesion as a function of temperature, where adhesiveness increases with increasing pad temperature. Once printing is complete and the pad has subsequently cooled, the model can be easily removed from the print pad. It is a liquid product, gas-free, environmentally friendly and does not produce any unpleasant odours during printing, on the contrary it delivers a pleasant vanilla scent.
This product is water soluble and easy to clean. Increased adhesion has been confirmed for materials such as PLA, PLA-ST, ABS, ABS+, ABS-T, HIPS, ASA, TPU, PET-G.
Application procedure:
Thoroughly clean the printing surface of the printer. Make sure the temperature of the print pad is below 50°C.
Shake the Devil Design adhesive for a few seconds and then apply to the (unheated) print pad. Unscrewing the cap, you will find a sponge applicator that allows you to apply the adhesive precisely only where it is actually needed.
Allow approximately 2 minutes for the surface to dry completely before heating the pad to the desired temperature depending on the filament type selected. Recommended working temperatures are given in the table below.
When you have finished printing the 3D object, wait for the print pad to cool down. The model should slide off the pad easily once it has cooled.